Real NSE7_EFW-6.4 are Uploaded by TestKingFree provide 2021 Latest NSE7_EFW-6.4 Practice Tests Dumps.
All NSE7_EFW-6.4 Dumps and Fortinet NSE 7 - Enterprise Firewall 6.4 Training Courses Help candidates to study and pass the Fortinet NSE 7 - Enterprise Firewall 6.4 Exams hassle-free!
NEW QUESTION 39
A FortiGate is rebooting unexpectedly without any apparent reason. What troubleshooting tools could an administrator use to get more information about the problem? (Choose two.)
- A. Crashlogs.
- B. Logs.
- C. Firewall monitor.
- D. Policy monitor.
Answer: A,B
NEW QUESTION 40
Examine the output from the 'diagnose vpn tunnel list' command shown in the exhibit; then answer the question below.
Which command can beused to sniffer the ESP traffic for the VPN DialUP_0?
- A. diagnose sniffer packet any 'port 4500'
- B. diagnose sniffer packet any 'esp'
- C. diagnose sniffer packet any 'port 500'
- D. diagnose sniffer packet any 'host 10.0.10.10'
Answer: A
Explanation:
Explanation
NAT-Tis enabled. natt: mode=silentProtocol ESP is used. ESP is encapsulated in UDP port 4500 when NAT-T is enabled.
NEW QUESTION 41
Examine the output from the BGP real time debugshown in the exhibit, then the answer the question below:
Which statements are true regarding the output in the exhibit? (Choose two.)
- A. The state of the remote BGP peer will go toConnectafter it confirms the received prefixes.
- B. The state of the remote BGP peer isOpenConfirm.
- C. BGP peers have successfully interchangedOpenandKeepalivemessages.
- D. Local BGP peer received a prefix fora default route.
Answer: C,D
NEW QUESTION 42
Whendoes a RADIUS server send an Access-Challenge packet?
- A. The server does not have the user credentials yet.
- B. The server requires more information from the user, such as the token code for two-factor authentication.
- C. The user account is not found in the server.
- D. The user credentials are wrong.
Answer: B
NEW QUESTION 43
View the exhibit, which contains the partial output of an IKE real-time debug, and then answer the question below.
Why didn't the tunnel come up?
- A. The remote gateway's phase 2configuration does not match the local gateway's phase 2 configuration.
- B. The remote gateway's phase 1 configuration does not match the local gateway's phase 1 configuration.
- C. The remote gateway is using aggressive mode and the local gateway is configured to use man mode.
- D. The pre-shared keys do not match.
Answer: B
NEW QUESTION 44
What events are recorded in the crashlogs of a FortiGate device? (Choose two.)
- A. Configuration changes.
- B. Changes in the status of any of the FortiGuard licenses.
- C. System entering to and leaving from the proxy conserve mode.
- D. A process crash.
Answer: C,D
Explanation:
Explanation
diagnose debug crashlog read
275: 2014-08-05 13:03:53 proxy=acceptor service=imap session fail mode=activated276: 2014-08-05
13:03:53 proxy=acceptor service=ftp session fail mode=activated277: 2014-08-05 13:03:53 proxy=acceptorservice=nntp session fail mode=activated278: 2014-08-06 11:05:47 service=kernel conserve=on free="45034 pages" red="45874 pages" msg="Kernel279: 2014-08-06 11:05:47 enters conserve mode"280: 2014-08-06 13:07:16 service=kernel conserve=exit free="86704 pages" green="68811 pages"281: 2014-08-06 13:07:16 msg="Kernel leaves conserve mode"282: 2014-08-06
13:07:16 proxy=imd sysconserve=exited total=1008 free=349 marginenter=201283: 2014-08-06 13:07:16 marginexit=302
NEW QUESTION 45
What is the diagnose test application ipsmonitor 99 command used for?
- A. To disable the IPS engine
- B. To provide information regarding IPS sessions
- C. To enable IPS bypass mode
- D. To restart all IPS engines and monitors
Answer: D
NEW QUESTION 46
View the exhibit, which contains a session entry, and then answer the question below.
Which statement is correct regarding this session?
- A. It is a TCP session in CLOSE_WAIT state from 10.1.10.10 to 10.200.1.1.
- B. It is an ICMP session from 10.1.10.10 to 10.200.5.1.
- C. It is a TCP session in ESTABLISHED state from 10.1.10.10 to 10.200.5.1.
- D. It is an ICMP session from 10.1.10.10 to 10.200.1.1.
Answer: B
NEW QUESTION 47
View the exhibit, which contains a partial routing table, and then answer the question below.
Assuming all the appropriate firewall policies are configured, which of the following pings will FortiGate route?(Choose two.)
- A. Source IP address 10.72.3.52, Destination IP address 10.1.0.254.
- B. Source IP address 10.72.3.27, Destination IP address 10.1.0.52.
- C. Source IP address 10.1.0.24, Destination IP address 10.72.3.20.
- D. Source IP address10.73.9.10, Destination IP address 10.72.3.15.
Answer: A,B
NEW QUESTION 48
Refer to exhibit, which contains the output of a BGP debug command.
Which statement explains why the state of the 10.200.3.1 peer is Connect?
- A. The TCP session to 10.200.3.1 has not completed the 3-way handshake.
- B. The local router has received the BGP prefixes from the remote peer.
- C. The local router is receiving BGP keepalives from theremote peer, but the local peer has not received the OpenConfirm yet.
- D. The local router is receiving the BGP keepalives from the peer, but it has not received a BGP prefix yet.
Answer: A
Explanation:
Explanation
BGP neighbor states and how they change:* Idle: Initial state* Connect: Waiting for a successful three-way TCP connection* Active: Unable to establish the TCP session* OpenSent: Waiting for an OPEN message from the peer* OpenConfirm: Waiting for the keepalive message from the peer* Established: Peers have successfully exchanged OPEN and keepalive messages
NEW QUESTION 49
View the exhibit, which contains the output of a diagnose command, and then answer the question below.
What statements are correct regarding the output? (Choose two.)
- A. Traffic in the original direction (coming from the IP address 10.171.122.38) will be routed to the next-hop IP address 10.200.1.1.
- B. This is anexpected session created by a session helper.
- C. Traffic in the original direction (coming from the IP address 10.171.122.38) will be routed to the next-hop IP address 10.0.1.10.
- D. This is an expected session created by an application control profile.
Answer: A,B
NEW QUESTION 50
View the exhibit, which contains the output of a diagnose command, and then answer the question below.
Which statements are true regarding the output in the exhibit? (Choose two.)
- A. FortiGate will probe 121.111.236.179 every fifteen minutes for a response.
- B. Servers with the D flag are considered to be down.
- C. Servers with a negative TZ value are experiencing a service outage.
- D. FortiGate used 209.222.147.3 as the initial server to validate its contract.
Answer: A,D
Explanation:
Explanation
A - because flag is Failed so fortigate will check if server is available every 15 minD-state is I , contact to validate contract info
NEW QUESTION 51
Which of the following statements are correct regardingapplication layer test commands? (Choose two.)
- A. They are used to filter real-time debugs.
- B. Some of them display statistics and configuration information about a feature or process.
- C. They display real-time application debugs.
- D. Some of them can beused to restart an application.
Answer: B,D
Explanation:
Explanation
Application layer test commands don't display info in real time, but they do show statistics and configuration info about a feature or process. You can also use some of these commands to restart a pr ocess or execute a change in its operation.
NEW QUESTION 52
Refer to the exhibit, which contains a TCL script configuration on FortiManager.
An administrator has configured the TCL script onFortiManager, but failed to apply any changes to the managed device after being executed.
Why did the TCL script fail to make any changes to the managed device?
- A. The TCL command run_cmd has not been created.
- B. Incomplete commands are ignored in TCL scripts.
- C. Changes in an interface configuration can only be done by CLI script.
- D. The TCLscript must start with #include <>.
Answer: A
NEW QUESTION 53
View the exhibit, which contains a partial web filter profile configuration, and then answer the question below.
Which action willFortiGate take if a user attempts to access www.dropbox.com, which is categorized as File Sharing and Storage?
- A. FortiGate will block the connection as an invalid URL.
- B. FortiGate will exempt the connection based on the Web Content Filter configuration.
- C. FortiGate will block the connection based on the URL Filter configuration.
- D. FortiGate will allow the connection based on the FortiGuard category based filter configuration.
Answer: C
Explanation:
Explanation
fortigate does it in order Static URL -> FortiGuard -> Content -> Advanced (java, cookie removal..)so block it in first step
NEW QUESTION 54
A corporate network allows Internet Access to FSSO users only. The FSSO user student does not have Internet access after successfully logged into the Windows AD network. The output of the 'diagnose debug authd fsso list' command does not show student as an active FSSO user. Other FSSO users can access the Internet without problems. What should the administrator check? (Choose two.)
- A. The student workstation's IP subnet must be listed in the CA's trusted list.
- B. The user student must belong to one or more of the monitored user groups.
- C. At least one of thestudent's user groups must be allowed by a FortiGate firewall policy.
- D. The user student must not be listed in the CA's ignore user list.
Answer: C,D
Explanation:
Explanation
https://kb.fortinet.com/kb/documentLink.do?externalID=FD38828
NEW QUESTION 55
Examine the output of the 'get router info bgp summary' command shown in the exhibit; then answer the question below.
Which statements are true regarding the output in the exhibit? (Choose two.)
- A. Local BGP peer has not received an OpenConfirm from 10.200.3.1.
- B. The local BGP peer has received a total of 3 BGP prefixes.
- C. BGP peer 10.200.3.1 has never beendown since the BGP counters were cleared.
- D. BGP state of the peer 10.125.0.60 is Established.
Answer: A,D
NEW QUESTION 56
View the exhibit, which contains a screenshot of some phase-1settings, and then answer the question below.
The VPN is up, and DPD packets are being exchanged between both IPsec gateways; however, traffic cannot pass through the tunnel. To diagnose, the administrator enters these CLI commands:
However, the IKE real time debug does not show any output. Why?
- A. The debug output shows phase 1 negotiation only. After that, the administrator must enable the following real time debug: diagnose debug application ipsec -1.
- B. The debug shows only error messages. If there is no output, then the tunnel is operating normally.
- C. The log-filter setting was set incorrectly. The VPN's traffic does not match thisfilter.
- D. The debug output shows phases 1 and 2 negotiations only. Once the tunnel is up, it does not show any more output.
Answer: C
NEW QUESTION 57
An administrator has enabled HA session synchronization in a HA cluster with two members. Which flag is added to a primary unit's session to indicate that it has been synchronized to the secondary unit?
- A. dirty.
- B. nds.
- C. redir.
- D. synced
Answer: D
Explanation:
Explanation
The synced sessions have the 'synced' flag. The command 'diag sys session list' can be used to see the sessions on the member, with the associated flags.
NEW QUESTION 58
View the global IPS configuration, and then answer the question below.
Which of the following statements is true regarding this configuration?
- A. FortiGate will spawn IPS engine instances based on the system load.
- B. New packets will be passed through without inspection if the IPS socket buffer runs out of memory.
- C. IPS will scan every byte in every session.
- D. IPS will use the faster matching algorithm which is only available for units with more than 4 GB memory.
Answer: C
NEW QUESTION 59
Examine the output from the 'diagnose debug authd fsso list' command; then answer the question below.
# diagnose debug authd fsso list-FSSO logons-IP: 192.168.3.1 User: STUDENT Groups: TRAINI NGAD/USERS Workstation: INTERNAL2. TRAINING. LAB The IP address 192.168.3.1 is NOT the one used by the workstation INTERNAL2. TRAINING. LAB.
What should the administrator check?
- A. The IP address recorded in the logon event for the user STUDENT.
- B. The reserve DNS lookup forthe IP address 192.168.3.1.
- C. The DNS name resolution for the workstation name INTERNAL2. TRAINING. LAB.
- D. The source IP address of the traffic arriving to the FortiGate from the workstation INTERNAL2.
TRAINING. LAB.
Answer: D
NEW QUESTION 60
......
Valid Way To Pass Fortinet's NSE7_EFW-6.4 Exam with : https://www.testkingfree.com/Fortinet/NSE7_EFW-6.4-practice-exam-dumps.html
Free Test Engine For Fortinet NSE 7 - Enterprise Firewall 6.4 Certification Exams: https://drive.google.com/open?id=1sTSFAZqQgPifCHJnH1s9cC2z5T0apeld