Master 2021 Latest The Questions Dell Certified Specialist and Pass DES-DD23 Real Exam!
Penetration testers simulate DES-DD23 exam PDF
NEW QUESTION 24
An organization uses tape libraries in their current backup infrastructure. They have purchased a PowerProtect DD system and plan to use VTL to move from physical tape.
What is a consideration when configuring the tape size?
- A. Set retention periods for as long as possible
- B. Use larger tapes for multiple smaller datasets
- C. Use multiple drives to write multiple streams
- D. Target multiple drives to write single stream
Answer: C
NEW QUESTION 25
What are the steps to configure the Retention Lock Compliance?
Answer:
Explanation:
Reference:
https://datastorageasean.com/sites/default/files/EMC-data-domain-retention-lock-wp.pdf
NEW QUESTION 26
Which port/protocol is used when using a syslog server to monitor a PowerProtect DD system?
- A. 2051/TCP
- B. 2051/UDP
- C. 514/TCP
- D. 514/UDP
Answer: D
NEW QUESTION 27
What is the order of steps to configure DD Boost on the backup host?
Answer:
Explanation:
NEW QUESTION 28
An administrator is migrating their old cloud tier-enabled Data Domain to a new PowerProtect DD appliance with cloud tier. During migration, the administrator recognizes that file system cleaning on the source system is not possible.
What is the most likely cause of this behavior?
- A. Filesystem is disabled on source system.
- B. Migration will restrict all activities on source systems.
- C. Migration will restrict all activities on both systems.
- D. Source system is running in restricted mode.
Answer: B
NEW QUESTION 29
A PowerProtect DD appliance with two expansion shelves is being installed in a customer-provided rack. When cabling the controller to the shelves, what is connected to the host port on the last shelf in the chain?
- A. Expansion port of the controller
- B. Expansion port of the upstream shelf
- C. Host port of the downstream shelf
- D. Host port of the controller
Answer: B
NEW QUESTION 30
Which are supported compression algorithms in DDOS?
- A. bmp, lz, and gz
- B. dsp, gz, and lz
- C. lz, gz, and gzfast
- D. rle, lzw, and lz
Answer: C
NEW QUESTION 31
When using the DD VTL Tape Out to Cloud feature, which status will a tape show once it is in the cloud tier vault?
- A. Offsite
- B. Archived
- C. Vaulted
- D. Offline
Answer: C
NEW QUESTION 32
A technician is upgrading a DD9400 with a DS60 expansion shelf with 60 drives. In the GUI interface, only 30 drives are accessible.
What is causing these drives to be inaccessible?
- A. There are not enough cache drives on the DD9400 to support the extra capacity.
- B. A second SAS connection from DD9400 to DS60 is not activated.
- C. There are not enough spare drives.
- D. The capacity license applied is only for 30 drives.
Answer: B
NEW QUESTION 33
What is a requirement to configure the PowerProtect DD tape out to cloud feature?
- A. Two cloud units
- B. Tape Out to Cloud License
- C. DDVE in the Cloud
- D. Cloud Tier Capacity License
Answer: D
Explanation:
DD VTL supports storing the VTL vault on Cloud Tier storage. To use this functionality, the protection system must be a supported Cloud Tier configuration, and have a Cloud Tier license in addition to the VTL license.
NEW QUESTION 34
Refer to the exhibit.
To which shelf and port should SAS HBA slot 1 port B be connected?
- A. Shelf 04 BE
- B. Shelf 01 BE
- C. Shelf 01 BH
- D. Shelf 04 BH
Answer: D
NEW QUESTION 35
An engineer is configuring a PowerProtect DD system for VTL using Fibre Channel. How should the zones be configured?
- A. Hard zones
- B. Soft zones
- C. Single initiator, multi target
- D. Single initiator, single target
Answer: C
NEW QUESTION 36
What is the correct sequence of steps to configure storage for Dell EMC Cloud Tier in the DD System Manager?
Answer:
Explanation:
NEW QUESTION 37
A customer needs to use DD Retention Lock Compliance to ensure that data integrity is maintained. Which PowerProtect DD systems meet the customer's requirement?
- A. DD9400, DDVE, and DD9900
- B. DD3300, DD6900, and DD9400
- C. DD6900, DDVE, and DD9400
- D. DDVE, DD3300, and DD6900
Answer: B
NEW QUESTION 38
What can be used to monitor system utilization?
- A. system status command
- B. Health tab in the System Manager GUI
- C. system show performance command
- D. Alert Messages
Answer: D
NEW QUESTION 39
Which protocol is used for communications between a PowerProtect DD appliance and cloud tier to Dell EMC ECS?
- A. FTP
- B. SSL
- C. SSH
- D. HTTPS
Answer: D
NEW QUESTION 40
An administrator is configuring a Google Cloud Provider cloud unit on their DD9900. Which certificate must be imported before adding the cloud unit?
- A. Root CA
- B. GlobalSign Root R2
- C. S3 Flexible
- D. GlobalSign Root R1
Answer: B
NEW QUESTION 41
What happens to the data when it is moved from the active tier to cloud tier?
- A. It is compressed and stored in block storage in a new format
- B. It is deduplicated and stored in object storage the native format
- C. It is compressed and stored as object storage in a new format
- D. It is deduplicated and stored in a file system in the native format
Answer: B
NEW QUESTION 42
What is the maximum capacity for a DDVE?
- A. 256 TB
- B. 64 TB
- C. 96 TB
- D. 128 TB
Answer: A
NEW QUESTION 43
Which command is used to start the initial CLI configuration wizard?
- A. install config
- B. setup
- C. config setup
- D. config
Answer: C
NEW QUESTION 44
Which of the following protocols are supported by PowerProtect DD for data movement to a cloud provider?
- A. VTL and DD Boost
- B. FTP and FTPS
- C. CIFS and NFS
- D. HTTP and HTTPS
Answer: C
NEW QUESTION 45
......
Penetration testers simulate DES-DD23 exam: https://www.testkingfree.com/EMC/DES-DD23-practice-exam-dumps.html
Bestselling On-The-Job Reference Exam Questions: https://drive.google.com/open?id=1vbY-I9a6YaKN802hHM1LSYj1FyFDkT9n