2023 Correct Practice Tests of HPE6-A69 Dumps with Practice Exam
Certification Sample Questions of HPE6-A69 Dumps With 100% Exam Passing Guarantee
HP HPE6-A69 exam is an important certification for IT professionals who want to specialize in switching and networking. It is designed to validate the skills and knowledge of professionals in the field of switching and is an important step towards becoming an Aruba Certified Switching Expert. With the right preparation, candidates can pass the exam and take their careers in networking to the next level.
NEW QUESTION # 19
(Scenarios may contain multiple errors which may or may not Impact the solution) Refer to the exhibit.
An engineer has attempted to configure two pairs of switches in the referenced configuration, it is required to implement Multi-Chassis Link Aggregation for each pair of switches The ports of the Aruba 8325 switches used for Agg01 and Agg02 are populated as follows:
There is an error message staling "incompatible interface." Which interfaces are the cause of the error? (Select two.)
- A. 1/1/13 10GBaseT SFP+ 30m Cat6A Transceiver
- B. 1/1/12 10GBaseT SFP*+ 30m Cat6A Transceiver
- C. 1/1/48 iGBaseT 100m Cat5e Transceiver
- D. 1/1/49 40G QSFP+ 15m Active Optical Cable
- E. 1/1/50 40G QSFP+ 15m Active Optical Cable
Answer: D,E
NEW QUESTION # 20
(Scenarios may contain multiple errors which may or may not Impact the solution > Refer to the exhibit.
An engineer has attempted to configure two pairs of switches in the referenced configuration it is required to implement VSX keep-alive at the aggregation layer.
The ports of the ArubaOS-CS 8325 switches used for Agg01 and Agg02 are populated as follows:
The configuration of switch AGG01 includes:
VSX keep-alive is not working. Which modification should you make lo resolve the error condition?
- A. Edit interface 1/1/48, adding the command "vpn-instance KA"
- B. Modify the Keepalive peer 192.168.20.2 source 192 168.20.1 command, adding "vrf KA"
- C. Edit the vsx-sync command, adding "keep-alive"
- D. Modify the Interface lag 2 command, removing "multi-chassis"
Answer: D
NEW QUESTION # 21
An administrator warns to start a REST API session with an Aruba-OS CX switch Which HTTP method should the Administrator use to start a session?
- A. GET
- B. POST
- C. PUT
- D. LOGIN
Answer: B
NEW QUESTION # 22
A customer would like to utilize some ArubaOS-CX 6300M switches to perform OSPF routing.
All ports are routed, and ECMP is enabled, with other default parameters for OSPF. What will be the result of traffic sent from CLIENT-A to CUENT-B?
- A. Traffic will be SW3 -> SW-1 -> sw-4 -> SW-2
- B. Traffic will be SW3 -> SW-4 -> SW-2.
- C. Traffic win be SW3 -> SW-1 -> sw-2.
- D. Traffic will be SW3 -> SW-1 -> Sw-2 & SW3 -> SW-4 -> SW-2
Answer: A
NEW QUESTION # 23
Company A and Company B are merging their BGP routed networks The companies have overlapping IP ranges and security concerns during the migration phase. Which Aruba CX 8325 functionality would help the merging of networks in a secure way?
- A. Use of ACL's to separate the company networks at the VLAN level
- B. Use of vsf capable switch to integrate the routing
- C. Use of Aruba Gateway appliance to control the routes between merged networks
- D. Use of virtual route forwarding and BGP route leaking
Answer: C
NEW QUESTION # 24
Match the repotted status to the Aruba 8325 issue (Each option may Be used once more than once, or not at all)
Answer:
Explanation:
NEW QUESTION # 25
You need to establish a baseline summary of an ArubaOS-CX switch resource utilization after enabling new NAE scripts. How should you define a baseline for switch resource consumption? (Select two.)
- A. top cpu
- B. show system memory
- C. top memory
- D. show system cpu
Answer: A,C
NEW QUESTION # 26
The customer is considering Implemented the following VSX configuration that will host an Aruba mobility cluster servicing 9000 dual stack employee devices.
The client's default gateways will be hosted on the VSX stack. The customer is seeking advice about how to ensure ArubaOS-CX VSX best practices have been applied.
What advice can you offer the customer? (Select two)
- A. The Keepalive interface should be changed to interface LAG2 so there is redundancy through the mobility cluster.
- B. Agg-1 and Agg-2's hardware forwarding table profile should be changed to "L3-agg''.
- C. The -system-mac' of Agg-1 should be changed to an unused address from the unicast private address range
- D. The ISL Bandwidth should be upgraded
- E. The keepalive subnet is misconfigured, it has an inappropriate address on Agg-1.
- F. The vsx linkup-delay timer is unnecessarily high; it should be reduced to prevent excessive delay of packet forwarding when a VSX peer joins an existing master.
Answer: B,E
NEW QUESTION # 27
How Is voice Traffic prioritized correctly on ArubaOS-CX switches?
- A. By attaching the QoS settings directly to device profiles
- B. By implementing TOS-profiles
- C. By defining voice VLANs inside VLAN context
- D. By placing it in the strict priority queue
Answer: B
NEW QUESTION # 28
(Scenarios may contain multiple errors which may or may not impact the solution ) Refer to the exhibit.
An engineer has attempted to configure two pairs of switches in the referenced configuration It is required to implement VSX at the aggregation layer The pons of the ArubaOS-CX 8325 switches used for Agg01 and Agg02 are populated as follows:
The configuration of switch AGG01 includes
The VSX cluster is not forming. Which modification should you make to resolve the error condition?
- A. Modify the vsx definition, changing "inter-switch-link lag 2" to" inter-switch-link lag 256"
- B. Edit the vsx-sync command, adding "keep-alive"
- C. Modify the system interface-group 4 speed tOg command change "25g" to "10g"
- D. Modify the keepalive peer 192.168 20.2 source 192 168.20 1 command, changing "vrf KA" to "vrf mgmt"
Answer: C
NEW QUESTION # 29
A customer would like to utilize some ArubaOS-CX 6300F switches to perform OSPF routing.
With the ports set up as routed ports, and default parameters for OSPF. what is me OSPF cost for me connection between SW-3 and SW-4"?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: B
NEW QUESTION # 30
An administrator is utilizing the orchestration capabilities of NetEdit. What are the two plan types that can be created Configuration management plan
- A. Configuration plan
- B. Firmware plan
- C. Firmware plan
- D. Deployment plan
Answer: B,C
NEW QUESTION # 31
A customer is migrating from a Cisco VSS system to an ArubaOS-CX VSX cluster in order to provide default gateway functionality, the local network administrator creates VLAN interfaces The network administrator then migrates successfully from Cisco to Aruba The next day a manager asks if the solution is redundant. The network administrator realizes that there is no redundancy on the default gateway functionality What is the preferred solution with the least amount of configuration and disturbance?
- A. Remove the IP address on every VLAN interface, and replace it with another one in the same subnet Configure active gateway IP with the default gateway address on every VLAN interface on Doth switches
- B. For every VLAN interface, configure an active gateway IP with the same IP address as already present in the first VSX node Configure this on both switches
- C. For every VLAN Interface, configure a VRRP IP address with the same IP address as already present in the first VSX node. Configure this on both switches.
- D. Remove the IP address on every VLAN interface, and replace it with another one in the same subnet Configure VRRP with the default gateway address as virtual IP-address per VLAN.
Answer: D
NEW QUESTION # 32
Refer to the exhibit.
Which statement is true?
- A. Q1 and S1 are applied to all interfaces.
- B. Q1 and S1 are applied to all interfaces mat do not have a QoS override applied
- C. No default queues are changed
- D. To be effective, both Q1 and S1 still need to be applied to Interfaces
Answer: C
NEW QUESTION # 33
You are working with a customer whos has a paw of Aruba 8325 switches configured for Multi-Chassis Link Aggregation The customer is complaining that users are experiencing intermittent packet drops. Which action should be taken to quickly aid you in identifying the cause?
- A. Enable debug of vri with "console" set as the destination
- B. Check the configured VLANs using "show vsx config-consistency"
- C. Setup a mirror session to generate a Tshark file.
- D. Setup a mirror session to niter packets for TCPDUMP analysis
Answer: B
NEW QUESTION # 34
ArubaOS-CX 8325 VSX configuration has a Tailed ISL link between the switches with keepalive status established. While troubleshooting the condition, what is the expected behavior of the VSX traffic flow in the current condition?
- A. VSX tables are out of sync
- B. VSX protection state is OK
- C. VSX nodes Keep forwarding traffic over its interfaces
- D. VSX peer is seen as down
- E. vsx tables are n sync
Answer: C
NEW QUESTION # 35
The rate-limiting QoS feature can be implemented on all ArubaOS-CX platforms However, some features are platform dependent. Which statements are true'' (Select two.)
- A. Multicast and broadcast rate limits cannot be applied at the same time on the same Interface
- B. ICMP-Rate limiting is supported on all ArubaOS-CX platforms.
- C. Unknown unicast rate limiting is supported on all ArubaOS-CX platforms
- D. Broadcast-rate limiting is supported on all ArubaOS-CX platforms
Answer: A,B
NEW QUESTION # 36
Refer to the exhibit.
You want to protect the aggregation layer if the VSXISL falls. Where should you place a VSX keepalive link?
- A. On VSX LAG 1
- B. On a dedicated link created using port 1'1/48 of each aggregation switch
- C. On the OOBM ports of both aggregation switches
- D. On VSX LAG 101
Answer: C
NEW QUESTION # 37
A customer is having a performance issue on the network and has received complaints about users experiencing Intermittent connectivity. After performing a packet capture, It is determined that there is unwanted UDP port 68 traffic being broadcast
6300W%wit
To mitigate this issue, which ArubaOS-CX 6300M switch feature would be best to implement?
- A. bcms-optimization
- B. broadcast-limit
- C. dhcpv4-snooping
- D. private-vlan
Answer: C
NEW QUESTION # 38
When applying me following access-Iist to an ArubaOS-CX 6300 switch:
How does this ACL behave on the selected switch? (Select two.)
- A. The denied tcp traffic to the MANAGEMENT-SERVERS group is not logged to event logs
- B. The mp traffic to MANAGEMENT-SERVERS group is logged to me event logs
- C. The tftp traffic to MANAGEMENT-SERVERS group is not logged to the event logs.
- D. The denied tcp traffic to the MANAGEMENT-SERVERS group is logged to event logs.
- E. The snmp-trap traffic to MANAGEMENT-SERVERS is logged to the event togs.
Answer: A,C
NEW QUESTION # 39
A customer would like to utilize some ArubaOS-CX 6300F switches to perform OSPF routing.
With the ports set up as routed ports, and default parameters for OSPF, which action is the simplest way to allow the fastest communication...
- A. No action is required
- B. Utilize Equal-cost multi-path routing to aggregate more bandwidth on the WAN.
- C. Set the OSPF reference bandwidth to 10 or higher
- D. Set the OSPF cost parameters on every interface on every switch according to the Bandwidth or each link
Answer: A
NEW QUESTION # 40
The customer is already using Aruba Gateway and third-party L2 switches New ArubaOS CX 6300 switches have been deployed for R&D. which have a requirement for user profiling and tunneled traffic between ArubaOS CX 6300 and Aruba Gateway What is required for this configuration to apply QoS user-based rules for the R&D client traffic?
- A. Apply a port-access policy with QoS defined in the user role on the ArubaOS CX6300 switch
- B. Apply a QoS rule to the ArubaCX 6300 client port, lo classify traffic before it is tunneled.
- C. Manually prioritize IP protocol 47 traffic on the third-party switches to prioritize the tunneled traffic
- D. Create a QoS policy for the UBT-client-VLAN traffic on the third-party switch.
Answer: B
NEW QUESTION # 41
The customer is implementing new ArubaOS-CX 6300 switches into an environment that has third-party switches and uses centralized authentication from Microsoft Active Directory and TACACS* servers What would be a valid configuration requirement for ArubaOS-CX switches for centralized user authentication?
- A. Defining a TACACS server group for authentication in the switch configuration
- B. Importing a TACACS server certificate for TLS authentication into the switch
- C. Using a PAM extension for LDAP authentication with Active Directory Server.
- D. Enabling the active directory VSA in the switch for radius authentication
Answer: D
NEW QUESTION # 42
......
HPE6-A69 Sample Practice Exam Questions 2023 Updated Verified: https://www.testkingfree.com/HP/HPE6-A69-practice-exam-dumps.html
Pass Key features of HPE6-A69 Course with Updated 60 Questions: https://drive.google.com/open?id=1tPUO1OrI5UqWmzVF0mIarThZXX6CgumR